Hero Description

Real dry carbon fiber trim for the Tesla Cybertruck hazard light and P R N D switch panel.

The exposed weave adds sharper material contrast around one of the most frequently viewed control areas inside the cabin. More defined under changing light. More technical at close range.

Autoclave-cured dry carbon fiber construction with tighter weave clarity and reduced weight.

Quick Specs

• Tesla Cybertruck

• Hazard Light / P R N D Switch Panel Cover

• 100% Real Dry Carbon Fiber

• Autoclave Construction

• Interior Control Trim

• Non-Destructive Installation

Material

Constructed from real dry carbon fiber using an autoclave production process.

Compared to conventional wet carbon fiber construction, the surface provides:

• Cleaner weave consistency

• Reduced resin distortion

• Sharper edge definition

• Lower overall weight

The rigid composite structure also adds additional resistance against light scratches and daily contact around the switch panel area.

Fitment

Developed around the factory Cybertruck center control panel geometry.

The trim follows the original switch panel contours closely for cleaner alignment and more controlled edge transitions around the hazard light and gear selector area. No oversized edges or excessive trim thickness near touch surfaces.

Factory button and selector functionality remain unchanged after installation.

Appearance

The center switch panel sits within one of the most visually active areas inside the cabin.

Carbon fiber introduces stronger material separation around the control surface, creating more defined visual structure without disrupting the restrained interior architecture.

Especially noticeable under:

• Daylight entering through the windshield

• Ambient cabin lighting

• Nighttime dashboard reflections

Pairs naturally with carbon fiber dashboard trim, steering wheel accents, and center console components.

Before & After

Before installation, the factory switch panel surface can appear visually flat against surrounding cabin materials.

After installation:

• Sharper control area definition

• Cleaner material transitions

• More technical surface detailing

• Stronger focal contrast around the center controls

The visual change remains subtle from a distance and more noticeable during daily driving.

Installation

Non-destructive installation process.

Recommended steps:

1. Clean the switch panel surface thoroughly

2. Ensure the area is fully dry

3. Test-fit before final placement

4. Apply even pressure during installation

No drilling or permanent modification required.

Cleaning

For routine maintenance:

• Use a soft microfiber towel

• Clean with mild interior cleaner

• Wipe dry after cleaning

Avoid:

• Abrasive pads

• Strong solvents

• Rough polishing compounds

Proper care helps preserve weave clarity and carbon fiber surface finish over time.

FAQ

Is this made from real dry carbon fiber?

Yes. The switch panel cover is constructed from 100% real dry carbon fiber using an autoclave curing process.

Will installation affect the hazard light or gear selector controls?

No. The trim is developed around the factory control layout and does not interfere with normal button or selector operation.

Does the trim create excessive reflections while driving?

The exposed weave creates controlled reflections and sharper material contrast rather than excessive glare.

Will the finish match other Cybertruck carbon fiber interior parts?

Yes. The weave pattern and finish are intended to pair naturally with other exposed carbon fiber interior components.

Does installation require permanent modification?

No. Installation is fully non-destructive and does not require drilling or permanent changes.