ApexTeslas Tesla Model Y Juniper 2025 Rear Seat Cup holder Panel Cover Dry Carbon Fiber Interior
5Low stock
5In stock, ready to ship
Couldn't load pickup availability
Get notified by email when this product becomes available
Have a question?
Description
Hero Description
Real dry carbon fiber rear seat cup holder panel cover for the Tesla Model Y Juniper.
The exposed weave adds sharper surface contrast across the rear center console area, creating cleaner separation between the cup holder section and surrounding interior panels. More structured under cabin lighting. More technical in close detail.
Autoclave-cured dry carbon fiber construction with tighter weave clarity and reduced weight.
Quick Specs
-
Tesla Model Y Juniper (2025+)
-
Rear Seat Cup Holder Panel Cover
-
Real Dry Carbon Fiber
-
Autoclave Construction
-
Rear Interior Console Trim
-
Vehicle-Specific Fitment
Material
Constructed from dry carbon fiber with an autoclave-cured composite structure.
Compared to conventional wet carbon fiber construction, the surface provides:
-
Cleaner weave consistency
-
Reduced resin distortion
-
Sharper material definition
-
Lower overall weight
The exposed weave also introduces more controlled reflections across the rear console area under changing lighting conditions.
Fitment
Developed around the factory rear center console geometry of the Tesla Model Y Juniper.
The panel follows the original rear cup holder contours closely for cleaner alignment and more controlled surface transitions around high-contact passenger areas. No oversized edges or excessive trim thickness near storage or seating surfaces.
Factory rear console functionality remains unchanged after installation.
Appearance
The rear passenger area often features large uninterrupted interior surfaces.
Carbon fiber introduces stronger material layering around the rear cup holder section, creating more defined visual structure without disrupting the restrained cabin layout.
Especially noticeable under:
-
Ambient cabin lighting
-
Daylight entering through the glass roof
-
Nighttime interior reflections
Pairs naturally with front console carbon fiber trim, dashboard accents, and door panel components.
Before & After
Before installation, the rear cup holder area can appear visually flat against surrounding interior materials.
After installation:
-
Sharper rear console definition
-
Cleaner material transitions
-
More technical surface texture
-
Stronger visual detail within the rear cabin area
The visual change remains subtle from a distance and more noticeable at passenger seating positions.
Installation
Non-destructive installation process.
Recommended steps:
-
Clean the rear cup holder panel surface thoroughly
-
Ensure the area is fully dry
-
Test-fit before final placement
-
Apply even pressure during installation
No drilling or permanent modification required.
Cleaning
For regular maintenance:
-
Use a soft microfiber towel
-
Clean with mild interior cleaner
-
Wipe dry after cleaning
Avoid:
-
Abrasive pads
-
Strong solvents
-
Rough polishing compounds
Proper care helps preserve weave clarity and surface finish over time.
FAQ
Is this made from real dry carbon fiber?
Yes. The rear cup holder panel cover is constructed from real dry carbon fiber using an autoclave-cured process.
Will installation affect rear cup holder functionality?
No. The cover is developed around the factory rear console layout and does not interfere with normal operation or passenger usability.
Does the surface create excessive reflections inside the cabin?
The exposed weave creates controlled reflections and sharper material contrast rather than excessive glare.
Will the finish match other Tesla carbon fiber interior parts?
Yes. The weave pattern and finish are intended to pair naturally with other exposed carbon fiber interior components.
Does installation require permanent modification?
No. Installation is fully non-destructive and does not require drilling or permanent changes.