Hero Description

Real dry carbon fiber steering wheel trim for the Tesla Model 3 Highland.

The exposed weave adds sharper material contrast around the steering wheel center section, creating cleaner visual separation within the driver area. More structured under daylight. More technical at close range.

Autoclave-cured dry carbon fiber construction with tighter weave clarity and reduced weight.

Quick Specs

• Tesla Model 3 Highland (2024+)

• Steering Wheel Sticker Trim

• Real Dry Carbon Fiber

• Autoclave Construction

• Interior Driver Area Trim

• Vehicle-Specific Fitment

Material

Constructed from dry carbon fiber with an autoclave-cured composite structure.

Compared to conventional wet carbon fiber construction, the surface provides:

• Cleaner weave consistency

• Reduced resin distortion

• Sharper material definition

• Lower overall weight

The rigid composite structure also adds additional resistance against light scratches and daily contact around high-touch steering wheel surfaces.

Fitment

Developed around the factory steering wheel geometry of the Tesla Model 3 Highland.

The trim follows the original contours closely for cleaner alignment and more controlled edge transitions around the center steering section. No oversized edges or excessive trim thickness near touch areas.

Factory steering wheel functionality remains unchanged after installation.

Appearance

The steering wheel remains one of the most visually active surfaces inside the cabin.

Carbon fiber introduces stronger material layering across the center section, creating more defined visual structure without overpowering the restrained interior layout.

Especially noticeable under:

• Direct daylight through the windshield

• Ambient cabin lighting

• Nighttime dashboard reflections

Pairs naturally with carbon fiber dashboard trim, center console components, and door panel accents.

Before & After

Before installation, the factory steering wheel center area can appear visually flat against surrounding interior materials.

After installation:

• Sharper steering wheel definition

• Cleaner material transitions

• More technical surface texture

• Stronger focal detail within the driver area

The visual change remains subtle from a distance and more noticeable during everyday driving.

Installation

Non-destructive installation process.

Recommended steps:

1. Clean the steering wheel surface thoroughly

2. Ensure the area is fully dry

3. Test-fit before final placement

4. Apply even pressure during installation

No drilling or permanent modification required.

Cleaning

For routine maintenance:

• Use a soft microfiber towel

• Clean with mild interior cleaner

• Wipe dry after cleaning

Avoid:

• Abrasive pads

• Strong solvents

• Rough polishing compounds

Proper care helps preserve weave clarity and surface finish over time.

FAQ

Is this made from real dry carbon fiber?

Yes. The steering wheel trim is constructed from real dry carbon fiber using an autoclave-cured process.

Will installation affect steering wheel functionality?

No. The trim is developed around the factory steering wheel layout and does not interfere with normal operation.

Does the surface create excessive reflections while driving?

The exposed weave creates controlled reflections and sharper material contrast rather than excessive glare.

Will the finish match other Tesla carbon fiber interior parts?

Yes. The weave pattern and finish are intended to pair naturally with other exposed carbon fiber interior components.

Does installation require permanent modification?

No. Installation is fully non-destructive and does not require drilling or permanent changes.