Hero Description

Real dry carbon fiber side camera turn signal covers for the Tesla Model 3 and Model Y HW3.0 platforms.

The exposed weave adds sharper material contrast around the side repeater area, creating cleaner separation between the camera housing and surrounding body surfaces. More defined under direct sunlight. More technical at close range.

Autoclave-cured dry carbon fiber construction with tighter weave clarity and reduced weight.

Quick Specs

• Tesla Model 3 HW3.0 (2021–2023)

• Tesla Model Y HW3.0 (2021–2023)

• Outside Side Camera Turn Signal Cover

• Real Dry Carbon Fiber

• Autoclave Construction

• Exterior Camera Trim

Material

Constructed from dry carbon fiber with an autoclave-cured composite structure.

Compared to conventional wet carbon fiber construction, the surface provides:

• Cleaner weave consistency

• Reduced resin distortion

• Sharper material definition

• Lower overall weight

The rigid composite structure also adds additional resistance against light scratches and daily exterior wear around the camera housing area.

Fitment

Developed around the factory HW3.0 side camera and turn signal geometry of the Tesla Model 3 and Model Y platforms.

The covers follow the original repeater contours closely for cleaner alignment and more controlled surface transitions along the side body line. No oversized edges or excessive trim thickness around the camera housing.

Factory camera visibility and turn signal functionality remain unchanged after installation.

Appearance

The side repeater area remains one of the most visually detailed sections along the body profile.

Carbon fiber introduces stronger material layering around the camera housing, creating sharper side-body definition without disrupting the restrained exterior architecture.

Especially noticeable under:

• Direct sunlight across the side body line

• Parking garage lighting

• Nighttime street reflections

Pairs naturally with carbon fiber mirror caps, spoilers, and satin black exterior trim.

Before & After

Before installation, the factory side repeater area can appear visually flat against surrounding body surfaces.

After installation:

• Sharper side profile detailing

• Cleaner material transitions

• More technical exterior texture

• Stronger visual definition around the camera housing

The visual change remains subtle from a distance and more noticeable at side viewing angles.

Installation

Non-destructive installation process.

Recommended steps:

1. Clean the camera housing surface thoroughly

2. Ensure the area is fully dry

3. Test-fit before final placement

4. Apply even pressure during installation

No drilling or permanent modification required.

Cleaning

For routine maintenance:

• Wash using mild automotive shampoo

• Use a soft microfiber towel

• Dry thoroughly after cleaning

Avoid:

• Abrasive polishing compounds

• Strong solvents

• Rough brushes or pads

Proper care helps preserve weave clarity and carbon fiber surface finish over time.

FAQ

Is this made from real dry carbon fiber?

Yes. The side camera turn signal covers are constructed from real dry carbon fiber using an autoclave-cured process.

Will installation affect camera or turn signal functionality?

No. The covers are developed around the factory HW3.0 camera and lighting layout and do not interfere with normal operation.

Does this fit HW4.0 Tesla models?

No. This version is specifically designed for 2021–2023 Tesla Model 3 and Model Y vehicles equipped with HW3.0 side cameras.

Will the finish match other Tesla carbon fiber exterior parts?

Yes. The weave pattern and finish are intended to pair naturally with other exposed carbon fiber exterior components.

Does installation require permanent modification?

No. Installation is fully non-destructive and does not require drilling or permanent changes.